location
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
location [2018/05/28 15:51] devreach |
location [2018/05/28 16:39] (current) |
||
|---|---|---|---|
| Line 63: | Line 63: | ||
| {{:cordsandraduisentered.png|}} | {{:cordsandraduisentered.png|}} | ||
| + | |||
| + | |||
| + | **__Create Circular Geofence__** | ||
| + | |||
| + | To create the geofence and send the geofence to the device, click the Create Circular Geofence button. This will present the usual popup where you can send the command to the device, add to a Location policy (once one has been created) or send to a group. | ||
| + | |||
| + | {{:creategeofencepopup.png|}} | ||
| + | |||
| + | |||
| + | |||
| + | The geofence has been created (below). Please wait a few seconds for the device to contact the EMM and for the page to refresh. | ||
| + | |||
| + | |||
| + | {{:geofencecreated.png|}} | ||
| + | |||
| + | |||
| + | **__Get Geofences__** | ||
| + | |||
| + | Click Get geofences to retrieve all geofences on a given device. This will populate the geofences table. | ||
| + | |||
| + | {{:geofencestable.png|}} | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | **__Start/Stop Geofencing__** | ||
| + | |||
| + | |||
| + | Once a geofence has been created, the Start or Stop geofencing commands can be sent to the device. The device will then start to check periodically whether the device's current location is either inside or outside a particular geofence. If a device is within a predetermined geofence, the geofence will appear in the 'Geofences Device Is located Within' table. | ||
| + | |||
| + | |||
| + | |||
| + | **__Set Min geofencing Check in Meters__** | ||
| + | |||
| + | |||
| + | This value must be a whole number and specifies how many meters the device can move before a geofence check is initiated. | ||
| + | Get Min geofencing Check in Meters button retrieves the value that is currently on the device. | ||
| + | |||
| + | **__Set Min geofencing Check in Minutes__** | ||
| + | |||
| + | |||
| + | This value must be a whole number and specifies how many minutes must elapse before a geofence check is initiated. | ||
| + | Get Min geofencing Check in Minutes button retrieves the value that is currently on the device. | ||
| + | |||
| + | |||
| + | {{:geofenceparams.png|}} | ||
| + | |||
| + | |||
| + | |||
| + | **__Destroy Selected Circular Geofence__** | ||
| + | |||
| + | In order to remove a geofence from the system and the device, select the radio button in the geofences table and click the 'Destroy Selected Circular Geofence' button. | ||
location.1527519085.txt.gz ยท Last modified: 2018/05/28 15:51 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
